DHUM-20 E dehumidifier

Cabinet

The cabinet is made of shock-resistant plastic in white and black. There is a suction grille at the back and a removable lid that covers the condensate container. The exhaust of the dried air is through louvres at the top of the cabinet. On the upper part of the cabinet there are indicator lights indicating the operation of the unit, the filling of the condensate container, the operation of the frost protection, the operation of the timer and the fan speed setting. There is also a display showing the internal relative humidity value. There is an opening at the rear of the cabinet to allow the condensate hose to be connected directly to the drain. The unit has carrying handles on the sides and is equipped with castors for easy travel.

El. connection

Connection via mains plug into a wall socket.

Speed control

Speed control consists of setting the desired relative humidity at which the dehumidifier should operate. In addition, it is possible to set the dehumidifier to run continuously regardless of the ambient humidity. The unit also allows an automatic mode in which it evaluates the recommended relative humidity based on the internal temperature. When the condensate container is full, the unit automatically stops and the alarm lights up. When operating in a room with a temperature below 15 °C, the frost protection is automatically activated and the signal lights up. In addition, the unit allows setting an automatic timeout of 1-24 hours. After the set time has elapsed, the unit automatically stops. The unit's fan can be switched in two power stages.

Noise

The noise emitted by the unit is measured at a distance of 1.5 m in the axis of the suction grille.

Mounting

The unit is mobile and can be easily carried thanks to the handles on the cabinet. The unit connects to the mains using its own plug cable. The unit should be positioned so that the intake and discharge openings are clear and to ensure free airflow around the unit. If the unit is placed in the same location for a long period of time, it is possible to drain the condensate directly to the drain with a hose (not included), so that there is no need to check the filling level of the condensate container. The unit should not be placed within the range of splashing water, near a heat source or in direct sunlight.

Instructions

The unit is designed for domestic use for dehumidifying the air in wet rooms, bathrooms, drying rooms, laundries, cellars, etc. Do not use in the immediate vicinity of bathtubs, showers and swimming pools.

Warning

The mains voltage and the cross-section of the supply cable must correspond to the values indicated on the type plate (on the back of the appliance, where the condensed water collection container is located). If a fixed electrical installation is required, it must be carried out by an electrician in accordance with the relevant electrical installation regulations. For safety reasons, do not use splitters. If the mains cable is damaged, it must only be replaced by the manufacturer or a customer service engineer or trained personnel to avoid potential hazards.

Caution! Sufficient space must be left on both the top and back of the dryer to ensure adequate air circulation.