EP-5N electric heater

Cabinet

The cabinet is made of sheet steel, coated with a burning varnish. On the cabinet is screwed a stand
made of steel pipe, which allows two basic positions to position the fan and at the same time to carry it.

Running wheel

The impeller is axial, moulded from Al sheet. The blades are performance optimised.

Motor

The motor is asynchronous with short armature and shielded pole. It is designed for continuous operation. The motor has grease-filled plain bearings for life. The motor has overload protection. Protection rating IP24.

El. connection

Connection is by a cable that is routed out of the enclosure through a grommet and terminated with a 5-pin 400 V fork.

The EP-3N model is single phase and the supply is provided with a single phase fork.

Regulation

Regulation is done by 2 controls directly on the unit. One sets the type of operation, the other controls the switching thermostat. Using the switch on the rear panel, it is possible to select whether the thermostat will run the fan and heat or only heat when the fan is permanently on.

Noise

The values shown in the table are the sound pressure values at a distance of 1.5 m.

Variants

- EP-3N basic design 3 kW/230 V
- EP-5N basic design 5 kW/400 V
- EP-9N basic design 9 kW/400 V
- EP-12N basic design 12 kW/400 V
- EP-15N basic design 15 kW/400 V

Instructions

Electrically heated fans are suitable for drying wet areas and for heating in industry and construction. The places of use are mainly production halls, warehouse halls, common rooms, churches, exhibition halls, buildings and construction site facilities, garages and workshops.

Information

The electrically heated fan is designed to operate on a horizontal pad or floor. When doing so, care must be taken not to cover the enclosure with heating rods on the intake or discharge side. If this is the case, the air flow through the cabinet could be restricted and the temperature could rise, with a consequent risk of fire. If the air temperature rises, the unit will be switched off by the safety thermostat, whose reset button is located on the top of the cabinet.

Types of operation:
- fan only
- fan and half power heating
- fan and full power heating

Warning

A safe distance from combustible structures, as specified by the user's operating rules, must be maintained.